Misidentification caused by leaky surface wave in high-frequency surface wave method

Multichannel analysis of surface waves (MASW) method analyses high-frequency surface waves to determine shear (S)-wave velocities of near-surface materials, which are usually unconsolidated and possess higher Poisson's ratios. One of key steps using the MASW method to obtain the near-surface S-wave velocities is to pick correct phase velocities in dispersive images. A high-frequency seismic survey conducted over near-surface materials with a higher Poisson's ratio will often result in data that contains non-geometric wave, which will raise an additional energy in the dispersion image. Failure to identify it may result in misidentification. In this paper, we have presented a description about leaky surface wave and the influence caused by the existence of leaky waves in a high-frequency seismic record. We first introduce leaky wave and non-geometric wave. Next, we use two synthetic tests to demonstrate that non-geometric wave is leaky wave and show the properties about leaky surface wave by eigenfunctions using Chen's algorithm. We show that misidentification may occur in picking the dispersion curves of normal Rayleigh wave modes because the leaky-wave energy normally connects energy of fundamental and/or higher modes. Meanwhile, we use a real-world example to demonstrate the influence of leaky wave. We also propose that muting and filtering should been applied to raw seismic records prior to generating dispersive images to prevent misidentifying leaky surface waves as modal surface waves by a real-world example. Finally, we use a three-layer model with a low-velocity half-space to illustrate that leaky surface waves appear on condition that the phase velocities are higher than maximum S-wave velocity of the earth model when solving the Rayleigh equation.