期刊
FUSION ENGINEERING AND DESIGN
卷 84, 期 7-11, 页码 1920-1924出版社
ELSEVIER SCIENCE SA
DOI: 10.1016/j.fusengdes.2008.12.001
关键词
Tungsten; Yttria; Yttrium; Mechanical alloying; Sintering
W-(0.3-2)Y2O3 and W-(0.3-2)Y materials (in wt.%) have been manufactured by conventional powder metallurgy methods including dry mechanical alloying of elemental powders in Ar atmosphere, cold pressing in air using a pressure in the range of 150-250 MPa and sintering at 1800 degrees C either in vacuum or in At atmosphere. The mechanical alloying time was optimized by means of X-ray diffractometry and scanning electron microscopy analyses of the particles. It was found that it should not exceed 15 h, in order to obtain small and homogeneous particle sizes and crystallite sizes and to avoid formation of WC impurities. The density of the sintered specimens was found to increase with Y2O3 and Y contents. The highest density of about 90% was obtained for the W-2Y material, while the highest microhardness of 1790 HV0,2 was measured for the W-2Y(2)O(3) material. Scanning electron microscopy observations revealed that sintering occurred, at least partially, from liquid phase, the amount of the corresponding dense regions increasing with the Y2O3 or Y content. (c) 2008 Published by Elsevier B.V.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据