Effect of spray drying conditions and feed composition on the physical properties of black mulberry juice powder

In this study, the effects of some processing parameters on moisture content, water activity, drying yield, bulk density, solubility, glass transition temperature (T-g), and microstructure of spray dried black mulberry (Morus nigra) juice powders were investigated. A pilot-scale spray dryer was employed for the spray drying process and maltodextrin with different dextrose equivalent (6, 9, and 20DE) and gum Arabic were used as carrier agent. Independent variables were inlet air temperature (110, 130, and 150 degrees C), compressed air flow rate (400, 600, and 800 L/h), concentration of drying aids (8, 12, and 16%) and percent replacement of maltodextrin (6 and 9DE) by gum Arabic and maltodextrin 20DE (25, 50, and 75%). Between the different drying aids, maltodextrin 6DE shows the best effect on the properties of black mulberry juice powders. The process drying yield ranges from 45 to 82%. The highest drying yield (82%) and solubility (87%) refer to the blend of maltodextrin 6DE and gum Arabic. The lowest moisture content powders (1.5%) produced at the compressed air flow rate of 800 L/h. Inlet air temperature negatively influenced the bulk density due to the increase of powder's porosity. The lower the bulk density, the higher the solubility of powder is. With regard to morphology, powders produced with maltodextrin and gum Arabic presented the smallest size. (C) 2012 The Institution of Chemical Engineers. Published by Elsevier B.V. All rights reserved.