Hexavalent chromium [Cr(VI)] removal by the electrochemical ion-exchange process

In the present investigation, the performance of a laboratory-scale plate and frame-type electrochemical ion-exchange (EIX) cell on removal of hexavalent chromium from synthetic wastewater containing 5mg/l of Cr(VI) was evaluated under varying applied voltages. Ruthenium dioxide-coated titanium plate (RuO (2)/Ti) was used as anode and stainless steel plates as cathode. The EIX cell was run at different hydraulic retention time (HRT). Before using in the electrochemical cell, the capacity of ion-exchange resin was evaluated through kinetic and isotherm equilibrium tests in batch mode. The batch kinetic study result showed that the equilibrium time for effective ion exchange with resin is 2h. The isotherm equilibrium data fit well to both Freundlich and Langmuir isotherms. Maximum capacity (q(m)) of resin calculated from Langmuir isotherm was 71.42mg/g. Up to 99% of chromium removal was noticed in the EIX cell containing fresh resin at applied voltages of 10V and higher. Migration of chromium ion to anode chamber was not noticed while performing the experiment with fresh resin. As high as 50% removal of chromium was observed from the middle chamber containing exhausted resin at an applied voltage of 25V when the influent flow rate was maintained at 45min of HRT. The performance of the reactor was increased to 72% when the influent flow rate was decreased to maintain at 90min of HRT. Build-up of chromium in the anode chamber took place when exhausted resin was used in the process.