4.7 Article

Evaluation of the Performance of Air Dense Medium Fluidized Bed (ADMFB) for Low-Ash Coal Beneficiation. Part 2: Characteristics of the Beneficiated Coal

期刊

ENERGY & FUELS
卷 27, 期 10, 页码 5607-5616

出版社

AMER CHEMICAL SOC
DOI: 10.1021/ef400457y

关键词

-

资金

  1. Carbon Management Canada (CMC)
  2. Canadian Centre for Clean Coal/Carbon and Mineral Processing Technologies (C5MPT)

向作者/读者索取更多资源

Low-rank coals are widely used as fuel in coal-fired power plants. Continuing the use of these fuels is under huge pressure because of stringent environmental regulations. The air dense medium fluidized bed (ADMFB), which is a dry physical coal beneficiation method, can offer an efficient and economical solution for ash removal. The performance of the ADMFB separator in preparing higher quality coals has been studied by detailed characterization of the ADMFB clean coal products with minimum ash content, maximum organic material recovery, or different feed particle sizes in the present work. The percentage of ash removal for the selected samples with particle size of 1-13.2 mm was between 9 and 22% with respect to the feed sample. An increase of all CHNS components and higher heating value (HHV), regardless of the coal particle size, and a very efficient mercury rejection of between 33.7 and 48.6% were observed for most of the beneficiated samples. Inductively coupled plasma-mass spectrometry (ICP-MS) analysis confirmed the decrease of most of the hazardous elements, such as Pb, Ag, Ba, Cu, Mn, Be, and K, indicating a positive affinity of these elements with the ash-forming minerals of the coal. Some elements, such as As, Se, and Sb, exhibited inconsistent results, which indicates various degrees of organic bonding for these elements. X-ray fluorescence (XRF) analysis of the ashes of the beneficiated coals revealed different decreasing levels of Si, Al, and Mg oxides (main components of clay minerals) and an increase of Na, Ca, and Fe oxides. Lower viscosities, a lower reducing ash fusion temperature (< similar to 1250 degrees C), and consequently, an increased slagging propensity based on a number of simple slagging indices for beneficiated products were obtained. The change in the reactivity of the clean coal products was discussed on the basis of the maximum rate of weight loss (R-max) and the peak temperature (T-max) obtained by differential thermogravimetry (DTG). The fine and middle size beneficiated samples showed various degrees of reactivity improvement. R-max for the middle size was found to increase by at least 84.5%, and T-max for the same was found to decrease by at least 62 degrees C.

作者

我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。

评论

主要评分

4.7
评分不足

次要评分

新颖性
-
重要性
-
科学严谨性
-
评价这篇论文

推荐

暂无数据
暂无数据