Interlaminar toughening of resin transfer moulded glass fibre epoxy laminates by polycaprolactone electrospun nanofibres

Delamination and brittle matrix fracture has since long been a problem of fibre reinforced composites. This paper investigates if polycaprolactone (PCL) nanofibre nonwovens can increase the interlaminar fracture toughness of resin transfer moulded glass fibre/epoxy laminates, without causing problems during impregnation and without negatively affecting other (mechanical) properties. The mode I fracture toughness was shown to be dependent on both the nanofibre content as well as on how the nanofibres were introduced into the laminates. Almost 100% improvement in fracture toughness could be achieved by electrospinning the PCL nanofibres on both sides of the glass fibre mats prior to impregnation. This led to a model fracture toughness of over 1200 J/m(2). Tensile and dynamic mechanical properties of the toughened laminates were not affected by the PCL nanofibres. It could be concluded that even state of the art infusion resins with a high intrinsic fracture toughness can benefit significantly from nanofibre toughening. (C) 2014 Elsevier Ltd. All rights reserved.