Surface modification of PET films by atmospheric pressure plasma exposure with three reactive gas sources

The surface modification of poly (ethylene terephthalate) (PET) film was carried out using an atmospheric pressure plasma (APP) jet device with three reactive gases: air, N-2, and Ar. The water contact angles on the PET film were found to decrease considerably after the APP exposure. The changes in the advancing and receding contact angles of water on the APP-exposed PET film with aging time were examined by the wetting force measurements employing the Wilhelmy method. The hydrophobic recovery due to the rinsing with water as well as the aging in air was observed only for the advancing angle, which was probably caused by the dissolution of low molecular weight oxidized materials into water, the loss of volatile oxidized species to the atmosphere and the reorientation and the migration of polymer chains. The wettability and the surface free energy of the APP-exposed PET film after diminishing hydrophobic recovery was sufficiently large compared with the untreated film. X-ray photoelectron spectroscopy confirmed that the PET film surface was oxidized due to the APP exposure. When N-2 gas was used for the APP exposure, the surface nitrogen concentration was found to increase with decreasing D. The surface oxygen concentration on the APP-exposed PET film was reduced by rinsing with water, in accordance with the hydrophobic recovery behavior. From atomic force microscopy, surface topographical change due to the APP exposure was observed. The changes in the PET surface properties due to the APP exposure as mentioned above were remarkable for using N-2 gas.