Experimental study on visible-light induced photocatalytic oxidation of gaseous formaldehyde by polyester fiber supported photocatalysts

Heterogeneous photocatalytic oxidation (PCO) has shown large potentials in controlling airborne gaseous pollutants such as volatile organic compounds (VOCs). This article addresses PCO of gaseous formaldehyde (HCHO) by VIS-active photocatalysts which were immobilized on polyester fiber filter through a spray coating method under room temperature. The coatings showed good dispersion and strong adhesion on the fiber surface as supported by the SEM images and the stability test result. High PCO efficiency was achieved by the spray-coated filter under typical room light illumination. The effects from various reaction parameters, such as volumetric flow rate, pollutant initial concentration, relative humidity, illumination strength, as well as photocatalyst loading amount, on the PCO efficiency were also evaluated systematically. A Langmuir-Hinshelwood model was used to examine the kinetics of VIS-PCO of HCHO. One of the important findings was that changes of relative humidity had little influence on the PCO efficiency at either low or high HCHO concentrations. Different from the UV-PCO process where hydroxyl radical (OH center dot) is the major oxidative species, the VIS-generated holes, h((VIS))(+), as well as the superoxide radical (O-2(center dot-)) were considered to contribute predominantly to the degradation of HCHO under visible light illumination. (C) 2012 Elsevier B.V. All rights reserved.