Relative importance of transformation temperatures and sulphur content on hot ductility of steels

Low (0.3%) and high manganese (1.4%) plain C-Mn steels with varying sulphur levels have had their hot ductility determined over the temperature range 700-1000degreesC, both after 'solution treatment' at 1330degreesC and directly after casting. It has been established that the width, depth and position of the hot ductility curves after solution treatment is more related to the transformation behaviour than either the sulphur in solution or the sulphide volume fraction or distribution. The growth of deformation induced ferrite at the austenite boundaries seems to be mainly diffusion controlled, and the higher is the transformation temperature for the gamma-alpha phase change, the faster is the growth. Large amounts of ferrite can then form, giving good ductility. Thus, high transformation temperatures Ae(3) or Ar-3 are required to produce narrow ductility troughs. It is believed that any detrimental influence of the sulphides on these 'solution treated' steels is swamped by the rapid increase in ferrite volume fraction. For the as cast state, as more sulphides are able to precipitate at the interdendritic boundaries and austenite grain boundaries than in the solution treated condition, increasing the sulphur level causes a small deterioration in ductility at the high temperature end of the trough. In the present work, only narrow troughs have been found. This is in contrast to previous work on as cast C-Mn -Nb-Al steels, which exhibited wide troughs in the ductility curves, where it was shown that higher total sulphur levels lead to considerably worse ductility and that sulphur can be as detrimental to the ductility as niobium. It is recommended that, to avoid transverse cracking during continuous casting, in addition to keeping the sulphur level low, the carbon and manganese should also be as low as possible.