期刊
MEDICAL ENGINEERING & PHYSICS
卷 29, 期 7, 页码 749-754出版社
ELSEVIER SCI LTD
DOI: 10.1016/j.medengphy.2006.08.009
关键词
microbubble; electrohydrodynamic; co-axial; atomization
资金
- EPSRC [EP/E012434/1] Funding Source: UKRI
- Engineering and Physical Sciences Research Council [EP/C547055/2, EP/C547055/1] Funding Source: researchfish
In this paper we report a novel method, based on co-axial electrohydrodynamic jetting, for the preparation of microbubble suspensions containing bubbles <10 mu m in size and having a narrow size distribution. No selective filtration is necessary and the suspensions are produced directly by the process. To demonstrate the method, glycerol was used as the liquid medium, flowing in the outer needle of the co-axial twin needle arrangement and undergoing electrohydrodynamic atomization in the stable cone-jet mode while air flowed through the inner needle at the same time. At zero applied voltage a hollow stream of liquid flowed from the outer needle. When the applied voltage was increased, eventually the hollow stream became a stable cone-jet and emitted a microthread of bubbles, which were collected in a container of glycerol to obtain microbubble suspensions. The size of the microbubbles was measured via optical microscopy and laser diffractometry. Several microbubble suspensions were prepared and characterised and the size distribution was found to be critically dependent on the ratio (n) of flow rates of liquid/air and, in particular the flow rate of the air. At n = 1.5, with the flow rate of air set at similar to 1.7 mu l/s, a microbubble suspension containing bubbles in the size range 2-8 mu m was obtained. (C) 2006 IPEM. Published by Elsevier Ltd. All rights reserved.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据