Copper ion-exchanged zeolite X from fly ash as an efficient adsorbent of phosphate ions from aqueous solutions

Zeolite X derived from fly ash was modified with Cu(NO3)2 center dot 3 H2O solutions of various initial concentrations (0.01, 0.05, 0.10, 0.15, and 0.20 M). The obtained materials were investigated by means of XRD, XRF, N2 adsorption-desorption, and pHpzc. The concentration of Cu(NO3)2 center dot 3 H2O significantly affected both the textural and chemical surface properties of the obtained zeolites. The materials were subjected to a series of adsorption experiments to remove phosphate ions from aqueous solutions. The highest adsorption capacity was obtained for zeolite X modified with 0.05 M Cu(NO3)2 center dot 3 H2O solution, and the obtained adsorption capacity was 87.7 mg (PO43-) g-1. The adsorption mechanism was investigated by means of XPS analysis and correlated with the as-sumptions of kinetic adsorption models. The interaction between phosphate ions and Cu species on the zeolite surface was found to be the guiding mechanism of adsorption. Additional mechanisms, including precipitation as calcium phosphate and electrostatic attraction, should also be taken into account. A single-point adsorption of phosphate ions was also studied to evaluate the effects of adsorbent dose (1, 2, and 3 g L-1) and adsorption temperature (18, 25 and 40 degrees C). Increased adsorbent dose resulted in a significantly greater removal of phos-phate ions for zeolite Cu0.05X (up to 65.4%). The temperature of 25 degrees C was found to be the most suitable for conducting adsorption of phosphate ions. Leaching test was performed in water to investigate the risk of applying the investigated zeolites in aqueous solutions as potential adsorbents.

Automated summary

Zeolite X derived from fly ash was modified with Cu(NO3)2 center dot 3 H2O solutions of various initial concentrations, and the obtained zeolites showed improved adsorption capacity for phosphate ions in aqueous solutions, with the optimum modification using 0.05 M Cu(NO3)2 center dot 3 H2O solution and a temperature of 25 degrees C for adsorption.