期刊
FOOD HYDROCOLLOIDS
卷 15, 期 3, 页码 247-252出版社
ELSEVIER SCI LTD
DOI: 10.1016/S0268-005X(01)00021-2
关键词
gellan; gel; fracture; strength in compression; velocity dependence; collective diffusion
The influence of the velocity of compression on the strength and the fracture profile in compression of cylindrical gellan gels was investigated in the concentration range from 0.81 to 2.5%. The fracture load and compression were obtained by analyzing the load-compression curves taken at various compression velocities. The fracture load F-b initially decreases, and then increases with decreasing compression velocity. The same tendency was observed for the compression velocity dependence of the fracture compression L-b The compression velocity at the minimum that determined from F-b-velocity curve, v(F), was slower than that determined from L-b-velocity curve, vc. In addition, it is found that the gellan gel was compressible to 90% without any macroscopic fracture when the compression velocity is smaller than a certain value V-unbroken Visual inspections indicated that the gel fractured at: an angle of almost 45 degrees from its parallel surface at the compression velocities above vc. On the other hand, several vertical breaks of 3-5mm around a cylindrical surface were observed in the velocity range from v(F) to V-unbroken Two types of fracture simultaneously occurred in the velocity range from v(C) to v(F). Below V-unbroken a gel became a sheet, in which most water flowed out of the gel without changing the radius of cylinder. The characteristic strain rate g, that estimated from V,,broken was interpreted in terms of the collective diffusion of the polymer network. (C) 2001 Elsevier Science Ltd. All rights reserved.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据