Solifluction rates, processes and landforms: a global review

Field data on the rates of solifluction and associated parameters are compiled from the literature, in an attempt to evaluate factors controlling the spatial variability in solifluction processes and landforms, with special attention on the climate-solifluction. relationship. The analyzed data originate from 46 sites over a wide range of periglacial environments, from Antarctic nunataks to tropical high mountains. Solifluction, broadly defined as slow mass wasting resulting from freeze-thaw action in fine-textured soils, involves several components: needle ice creep and diurnal frost creep originating from diurnal freeze-thaw action; annual frost creep, gelifluction and plug-like flow originating from annual freeze-thaw action; and retrograde movement caused by soil cohesion. The depth and thickness of ice lenses and freeze-thaw frequency are the major controls on the spatial variation in solifluction processes. Near the warm margin of the solifluction-affected environment, diurnal freeze-thaw action induces shallow but relatively rapid movement of a superficial layer 5 - 10 cm thick on average, often creating the thin stone-banked lobes typically seen on tropical high mountains. In addition to diurnal movement, annual frost creep and gelifluction may occur on slopes with soil climates of seasonal frost to warm permafrost, dislocating a soil layer shallower than 60 cm at a rate of centimeters per year and eventually producing medium-size solifluction lobes. In High-Arctic cold permafrost regions, two-sided freezing can induce plug-like flow of a soil mass 60 cm or thicker. The correlation between process and landform. suggests that the riser height of lobes is indicative of the maximum depth of movement and prevailing freeze-thaw type. Climate change may result in new different ground freezing conditions, thereby influencing the surface velocity and maximum depth of soil movement. Soil moisture and topography also control solifluction. High moisture availability in the seasonal freezing period enhances diurnal freeze-thaw action and subsequent seasonal frost heaving. The latter contributes to raising the moisture content of the thawed layer and promotes gelifluction during the thawing period. The slope angle defines the upper limit of the surface velocity of solifluction. A diagram correlating the potential frost creep with the actual surface velocity permits an inter-site comparison of the relative magnitude of solifluction components. Physically based modelling of periglacial slope evolution requires synthetic and more detailed field monitoring and laboratory simulations of solifluction processes. (C) 2001 Elsevier Science B.V. All rights reserved.