The acting wear mechanisms on metal-on-metal hip joint bearings:: in vitro results

Metal-on-metal (MOM) hip joint bearings are currently under discussion as alternatives to metal-on-polymer (MOP) bearings. Some criteria under scrutiny are the wear resistance, the influence of wear particles on the surrounding tissue, as well as the frictional torque. In order to understand and control the wear behavior of such a bearing a close correlation between the mi cro structures of the alloys used and the acting wear mechanisms has to be found. Thus, commercially available CoCrMo-balls were tested against self mating concave pins in a physiological fluid at 37 degreesC under reciprocating sliding wear (I Hz). The compressive load was 750 N (body weight). For 2 x 10(6) cycles tests were carried out continuously and with periodically occurring resting periods. On the basis of the observed wear appearances the acting wear mechanisms are defined and evaluated as to their contribution to the wear behavior. Due to the high local contact stresses surface fatigue prevails initially. Cr- and Mo-carbides are fractured and torn off the surfaces bringing about additional surface fatigue by indentations and initiating abrasion. The weight loss can be predominately attributed to these mechanically dominated wear mechanisms. In a parallel occurring tribochemical reaction layers are generated from denatured proteins. These adhere rigidly to the surfaces and cover parts of the contacting surfaces avoiding adhesion. Thus, the wear behavior is mainly influenced by the alternating balance between surface fatigue and abrasion on the one side and by tribochemical reactions on the other side. (C) 2001 Elsevier Science B.V. All lights reserved.