The generalized Leveque equation and its practical use for the prediction of heat and mass transfer rates from pressure drop

Based on the generalized Leveque equation (GLE) a new type of analogy between pressure drop and heat transfer has been discovered, that may be used in the cross corrugated channels of chevron type plate heat exchangers, in packed beds, in tube bundles, in crossed rod matrices or in many other spacewise periodic arrangements. Experimental data on heat transfer in tube bundles in crossflow, both inline, and staggered arrangements, had been recently tested in greater detail. Using an empirical correlation for pressure drop in these arrangements from the literature that has been successfully tested against a large number of experimental pressure drop data, heat transfer data collected earlier could be very well represented from the pressure drop correlation and the GLE. The data for staggered bundles have been shown to be in better agreement with this new method, than with the existing empirical heat and mass transfer correlations. Somewhat larger deviations for inline tube bundles had been found at lower Reynolds numbers. Here a simple and physically reasonable correction function of Re is presented, which leads to a better agreement for the inline bundles, too. Additionally, it can be shown for a number of literature data on tube bundles and on crossed rod matrices that the agreement with the GLE prediction is even better if original pressure drop data from the same sources are available in place of a pressure drop correlation. The method results in reasonable heat or mass transfer predictions from frictional pressure drop, which may be widely used in chemical engineering applications. (C) 2002 Elsevier Science Ltd. All rights reserved.