Synthesis and properties of azo dye aligning layers for liquid crystal cells

The synthesis and properties of azo dyes that can be used for photoaligning liquid crystals (LCs) have been investigated. The structures and the synthetic procedure for the azo dyes are presented. The photoaligning of azo dyes takes place purely due to the reorientation of the molecular absorption oscillators perpendicular to the UV light polarization. The qualitative model for the phenomenon in terms of the rotational diffusion of the azo dye molecules in the field of the polarized light is discussed. The order parameters S = -0.4 (80% of the maximum absolute value S-m = -0.5) were measured from the polarized absorption spectra at the wavelength 372 nm. A temperature stable pretilt angle of 5.3degrees was obtained by a two-step exposure of the azo dye film using normally incident polarized light followed by oblique non-polarized light. The azimuthal anchoring energy of the photoaligned substrate was A(phi) approximate to 10(-4) J m(-2), which is the same as the anchoring of the rubbed polyimide (PI) layer. The voltage holding ratio value of a photoaligned LC cell was found to be even higher than for a rubbed PI layer, which enables the applications of azo dyes as aligning layers in active matrix liquid crystal displays. The thermal stability of the photoaligned azo dye layers is sufficiently high, but UV stability has to be improved, e.g. by polymerization. A new LCD aligning technology based on polymerized azo dye layers is envisaged.