Integrated hydrochemical method of water quality assessment for irrigation in arid areas: application to the Jilh aquifer, Saudi Arabia

Water samples from 72 wells tapping the Jilh aquifer were collected and analyzed for 10 different water quality parameters. Using these data, a regional irrigation water quality was assessed using three techniques: (i) United States Department of Agriculture method (USDA), (ii) Food and Agriculture Organization (FAO) guidelines for water quality assessment, and (iii) Water-Types approach. The USDA method revealed that the aquifer water salinity, as represented by electrical conductivity, ECw, ranges from high salinity (C3: ECw > 0.75-2.25 dS/m) to a very high salinity (C4: ECw > 2.25 dS/m). The sodium adsorption ratio (SAR) varied from low (S1) to very high (S4) sodicity. Therefore, the water of the Jilh aquifer is dominantly of the C4-S2 class representing 56% of the total wells followed by C4-S1, C4-S3, C3-S1 and C4-S4 classes at 19%, 14%, 8%, and 3% of the wells respectively. The FAO system indicated moderate to severe restriction on the use for irrigation and slight to moderate ion toxicities for Na+, Cl-, B+, NO3- and HCO3-. It is clear that, both USDA and FAO systems condemn the Jilh groundwater as hazardous for irrigation due to its high salt content, unless certain measures for salinity control are undertaken. The dominant salt constituents in the water are Mg-Cl-2, Na-Cl and Ca-Cl-2 as per the Water-Types method. However, due to the complexity in classifying the aquifer groundwater for irrigation. a simplified approach acknowledging three class groups (I-suitable water, II-conditionally suitable water and III-unsuitable water) adopted from the three methods, is suggested in this paper. The simplified approach combines C-S classes of the USDA method among these three groups according to the lowest ratings. The salinity of the FAO method has been split arbitrarily into slight and moderate subclasses with values of 0.7-2.25 and >2.25 dS/m, respectively; to match with the C3-class of the USDA system. The Water-Types were classified assuming that Ca-Cl-2 is the least hazardous salt, followed by Mg-Cl-2 and Na-Cl. Using this integrated hydrochemical method, the majority of the wells (92%) contain unsuitable water for irrigation (Group 111) while the remaining wells (8%) are in Group II with water considered conditionally suitable for irrigation. (C) 2003 Elsevier Ltd. All rights reserved.