Controlling parameter analyses and hazard mapping for earthquake-triggered landslides: an example from a square region in Beichuan County, Sichuan Province, China

On May 12, 2008, at 1428 hours (Beijing time), a catastrophic earthquake, with a magnitude of Ms 8.0, struck the Sichuan Province, China. About 200,000 landslides, as a secondary geological hazard associated with the earthquake, were triggered over a broad area. These landslides were of almost all types such as shallow, disrupted landslides, rock falls, deep-seated landslides, and rock avalanches. Some of these landslides damaged and destroyed large part of some towns, blocked roads, dammed rivers, and caused other serious damages. The purpose of this study is to detect correlations between landslide occurrence and the surface rupture plane, ground shaking conditions (measured by peak ground acceleration, PGA), lithology, slope gradient, slope aspect, topographic position, and distance from drainages by using two indices, landslide area percentage (LAP) and the landslide number density (LND), based on geographic information system (GIS) technology and statistical analysis method in a square region (study area) of Beichuan County, Sichuan Province, China. There were 5,096 landslides related with the earthquake which were delineated by visual interpretation and selected field checking throughout the study area. The total area (horizontal projection) of the 5,096 landslides is about 41.103 km(2). The LAP, which is defined as the percentage of the plane area affected by landslides, was 10.276 %, and the LND, means the number of landslides per square kilometers, was 12.74 landslides/km(2). Statistical analysis results show that both LAP and LND have a positive correlation with slope gradient and a negative correlation with distance from the surface rupture. However, the correlation between the occurrence of landslides with PGA, topographic position, and distance from drainages are uncertain, or has just a little positive correlation. The correlation between landslide and slope aspect also shows the effect of the directivity of the seismic wave. The Zbq formation had the most concentrated landslide activity with the LND value of 21.78 landslides/km (,) (2) and the a(1) q Gr. geological units had the highest LAP value. Furthermore, weight index (W (i)) model is performed with a GIS platform to derive landslide hazard index map. The success rate of the model was 71.615 % and, thus, it was valid. In addition, comparison of five landslide controlling parameters' influence on landslide occurrences was also carried out.