Experimental verification of the role of interstitial fluid pressurization in cartilage lubrication

The objective of the current study was to measure the friction coefficient simultaneously with the interstitial fluid load support in bovine articular cartilage, while sliding against glass under a constant load. Ten visually normal 6-mm-diameter cartilage plugs harvested from the humeral head of four bovine shoulder joints (ages 2-4 months) were tested in a custom friction device under reciprocating linear motion (range of translation +/-2 mm; sliding velocity 1 mm/s), subjected to a 4.5 N constant load. The frictional coefficient was found to increase with time from a minimum value of mu(min) = 0.010 +/- 0.007 (mean +/- SD) to a maximum value of 0.243 +/- 0.044 over a duration ranging from 920 to 19,870 s (median: 4,560 s). The corresponding interstitial fluid load support decreased from a maximum of 88.8 +/- 3.8% to 8.7 +/- 8.6%. A linear correlation was observed between the frictional coefficient and interstitial fluid load support (r(2) = 0.96 +/- 0.03). These results support the hypothesis that the temporal variation of the frictional coefficient correlates negatively with the interstitial fluid load support and that consequently interstitial fluid load support is a primary mechanism regulating the frictional response in articular cartilage. Fitting the experimental data to a previously proposed biphasic boundary lubrication model for cartilage yielded an equilibrium friction coefficient of mu(eq) = 0.284 +/- 0.044. The fraction of the apparent contact area, over which the solid cartilage matrix was in contact with the glass slide was predicted at 0 = 1.7 +/- 6.3%, significantly smaller than the solid volume fraction of the tissue, phi(s) = 13.8 +/- 11.8%. The model predictions suggest that mixed lubrication prevailed at the contact interface under the loading conditions employed in this study. (C) 2003 Orthopaedic Research Society. Published by Elsevier Ltd. All rights reserved.