The role of particle size on the laser sintering of iron powder

The effects of powder particle size on the densification and microstructure of iron powder in the direct laser sintering process were investigated. Iron powders with particle sizes ranging from 10 to 200 mum were used. It was found that the sintered density increases as the laser energy input is increased. There is, however, a saturation level at which higher density cannot be obtained even at very intensive energy input. This saturation density increases as the size of the iron particles decreases. Meanwhile fine powders with narrow particle size distributions have a tendency toward agglomeration, and coarse powders with broad particle size distributions have a tendency toward segregation, both of them resulting in lower attainable density. In order to investigate the role of particle size, a densification coefficient (K) was defined and used. This coefficient depends on the particle size and the oxygen content of iron powder. The results of this investigation demonstrate that the presence of oxygen significantly influences the densification and pore morphology of laser-sintered iron. At higher oxygen concentrations, the iron melt pool is solidified to agglomerates, and formation of pores with orientation toward the building direction is more likely to occur. When the oxygen concentration is kept constant, the densification coefficient decreases with decreasing the particle size, meaning the densification kinetics enhances. This article presents the role of powder characteristics and the processing parameters in the laser sintering of iron powder as a model material. The mechanism of particle bonding and microstructural features of laser-sintered parts are addressed.