Effect of surfactant on the formation and dissociation kinetic behavior of methane hydrate

The effects of anionic surfactant sodium dodecyl sulfate (SDS) on the formation/dissociation kinetic behaviors of methane hydrate have been studied experimentally, with an emphasis put on dissociation kinetic behavior below ice point. The experimental results on hydrate formation show that the formation rates of methane hydrate could be speeded up by adding SDS to water and a critical SDS concentration of 650 ppm corresponding to a maximum storage capacity of 170V/V is determined. The SDS concentrations are fixed at this value in preparing hydrate samples for all dissociation tests. The dissociation experiments have been performed in two ways, at atmospheric pressure where the dissociation rates are determined by measuring the accumulative evolved gas volume, and in a closed system where the dissociation rates are determined by measuring the increasing system pressure profiles. For comparison, the dissociation tests with respect to two different cases, with and without the presence of SDS, are done in parallel. The results from tests in the first way show that the presence of SDS increases the dissociation rate of methane hydrate in whole temperature region below ice point. The results for the second way are somewhat different. The presence of SDS increases the dissociation rate and meta-stable system pressure in temperature region lower than 269.4 K. But when temperature is equal to or higher than 269.4 K, SDS speeds up the dissociation process only in beginning period, it turns to suppress the dissociation of methane hydrate several hours later and leads to a lower meta-stable system pressure compared with the case of without SDS. The experiments in closed system also demonstrate that the dissociating system approaches a meta-stable state with a pressure much lower than equilibrium dissociation pressure. (C) 2004 Elsevier Ltd. All rights reserved.