Novel conjugated linseed oil-styrene-divinylbenzene copolymers prepared by thermal polymerization. 1. Effect of monomer concentration on the structure and properties

A variety of novel opaque, white polymers ranging from rubbery materials to tough and rigid plastics have been prepared by the thermal polymerization at 85-160 degrees C of varying amounts of 87% conjugated linseed oil, styrene, and divinylbenzene. Gelation of the reactants typically occurs at temperatures higher than 120 degrees C, and fully cured thermosets are obtained after postcuring at 160 degrees C. The fully cured thermosets have been determined by Soxhlet extraction to contain approximately 35-85% cross-linked materials. The microcomposition of these polymers, as determined by H-1 NMR spectroscopy, indicates that the crosslinked materials are composed of both soft oily and hard aromatic phases. After solvent extraction, the insoluble materials exhibit nanopores well distributed throughout the polymer matrixes. Dynamic mechanical analysis of these polymers indicates that they are phase separated with a soft rubbery phase having a sharp glass transition temperature of -50 degrees C and a hard brittle plastic phase with a broadened glass transition temperature of 70-120 degrees C. These polymers possess cross-link densities of 0.15-2.41 X 104 mol/m(3), compressive Young's moduli of 12-438 MPa, and compressive strengths of 2-27 MPa. These materials are thermally stable below 350 degrees C and exhibit a major thermal degradation of 72-90% at 493-500 degrees C.