4.8 Article

Kinetic modeling of sulfur poisoning and regeneration of lean NOx traps

期刊

APPLIED CATALYSIS B-ENVIRONMENTAL
卷 100, 期 1-2, 页码 31-41

出版社

ELSEVIER
DOI: 10.1016/j.apcatb.2010.07.004

关键词

Catalyst deactivation; Kinetic modeling; Lean NOx traps; NOx storage; SO2; Sulfur poisoning and regeneration

资金

  1. Vinnova/Programradet for fordonsforskning [P26789-1]
  2. GM Powertrain Sweden
  3. Swedish Research Council [621-2003-4149, 621-2006-3706]
  4. Knut and Alice Wallenberg Foundation [Dnr KAW 2005.0055]
  5. GM RD Center

向作者/读者索取更多资源

Sulfur poisoning and regeneration of lean NOx traps were investigated using experiments and kinetic modeling. A commercial Pt, Rh and barium containing NOx storage catalyst was used. The catalyst also contained oxygen storage material. First the oxygen storage capacity (OSC) was investigated using steps with oxygen and hydrogen. The OSC was substantial with a total use of all hydrogen (1%) for about 20 s. The results were similar at the three investigated temperatures (300, 400 and 500 degrees C), indicating that it is a low activation barrier connected with the process. Further, no effect was observed when adding 15 ppm SO2 to the feed. Since no SO2 was observed in the outlet it is possible that SO2 is adsorbed during the lean period and then reduced to form H2S in the rich period (not measured). Further, the NOx storage was found to decrease during SO2 exposure, and the decrease was linear and dose dependent. In addition, we investigated different regeneration strategies. When using 500 ppm H-2 for 60 min at 700 degrees C the regeneration was poor. However, when adding 5% CO2 to the 500 ppm H-2 the regeneration was increased drastically. Further, the regeneration was decreased when decreasing the temperature to 600 degrees C, and further decreased when using 500 degrees C. In addition, it was beneficial with increasing the hydrogen concentration. The kinetic model contains three sub-models; (i)NOx storage and regeneration, (ii) oxygen storage and reduction and (iii) sulfur poisoning and sulfur regeneration. It was crucial to add NOx storage on two sites; barium and alumina. The NOx adsorbed on alumina is more loosely bound. Further, in the model formation of sulfates were added on both components. This was important in order to describe the rate of the sulfur deactivation. If sulfur was adsorbed only on barium the deactivation would have been too rapid. The model could describe the experimental features well. (C) 2010 Elsevier B.V. All rights reserved.

作者

我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。

评论

主要评分

4.8
评分不足

次要评分

新颖性
-
重要性
-
科学严谨性
-
评价这篇论文

推荐

暂无数据
暂无数据