Flue gas desulfurization in an internally circulating fluidized bed reactor

An internally circulating fluidized bed reactor (ICFBR) was used as a desulfurization apparatus in this study. The height of the bed was 2.5 m, and the inner diameter was 9 cm. The bed materials were calcium sorbent and silica sand. The effects of the operating parameters of the flue gas desulfurization including relative humidity, particle size of the calcium sorbent, inlet concentration of SO,, difference between the superficial gas velocities in the draft tube and the annulus, and superficial gas velocity in the draft tube on SO, removal efficiency (RE) were investigated. It was found that when the relative humidity (RH) was varied from 40% to 80%, the steady state RE had a largest value of approximately 15% when the relative humidity was 60%. When RH = 50%, 60% and 70%, RE decreased initially and then increased. After that RE decreased again until a steady state was reached. In addition, RE decreased with increasing calcium particle size or inlet SO2 concentration. A larger difference between the superficial gas velocities in the draft tube and the annulus had a higher RE resulting from increasing reactivity of the calcium sorbent caused by a higher attrition rate. Moreover, a higher attrition rate had a higher total volume of the flue gas treated. Finally, a model to predict the steady state RE in ICFBR was proposed. It assumed that the draft tube section was a bubbling fluidized bed while the annulus section was a moving bed. In addition, the effects of the calcium sorbent conversion, attrition rate and gas-bypassing fractions on RE were also taken into account in this model. It was found that the values of RE predicted by this model agreed with the experimental results. (c) 2005 Elsevier B.V. All rights reserved.