Causes of deactivation of bifunctional catalysts made up of CuO-ZnO-Al2O3 and desilicated HZSM-5 zeolite in DME steam reforming

The deactivation causes have been studied for bifunctional catalysts used in the reforming of dimethyl ether (DME). The kinetic runs have been carried out in a fluidized bed reactor in the 275-325 degrees C range. The bifunctional catalysts have been prepared using CuO-ZnO-Al2O3 (of different formulations) as metallic component, and HZSM-5 zeolites (of different acidity, moderated by desilication) as acid component. The study has been carried out by jointly evaluating: (i) the evolution of reaction indices (conversion of DME and methanol, and yields of H-2 and hydrocarbon by-products) with time on stream, and; (ii) the profiles of temperature programmed oxidation for the coke deposited on the deactivated catalysts in order to determine the content and location of the coke deposited; (iii) the physico-chemical properties of the deactivated catalysts. The deactivation results for the catalysts used in the reaction have been compared with those corresponding to the deactivation of the acid component in the step of DME hydrolysis and the metallic component in the step of methanol reforming. It has been determined that coke deposition on the metallic component is the main cause of the deactivation of bifunctional catalysts. This deposition is enhanced by increasing temperature, although the incorporation of Al2O3 in the formulation of the metallic component in the catalyst attenuates the partial blockage of metallic sites by coke. Below 325 degrees C, there is no Cu sintering and its oxidation is not the cause of deactivation. Furthermore, the deposition of coke on the acid component has a minor impact on deactivation. (C) 2014 Elsevier B.V. All rights reserved.