A closed-loop electronics cooling by implementing single phase impinging jet and mini channels heat exchanger

This paper reports our works in the design and testing of it closed-loop electronics cooling system that adopts bi-technologies: single phase impinging jet and mini channels heat exchanger, The system has the cooling capacity of 200 W over a single chip with a hydraulic diameter of 12 mm. The equivalent heat flux is 177 W/cm(2). The cooling system maintains the chip's surface temperature below 95 degrees C maximum when the ambient temperature is 30 degrees C. De-ionized water is the working fluid of the system. For the impinging jet, two different nozzles are designed and tested. The hydraulic diameters (d(N)) are 0.5 mm and 0.8 mm. The corresponding volume flow rates are 280 mL/min and 348 mL/min. Mini channels heat exchanger has 6 (six) copper tubes with the inner diameter of 1.27 mm and the total length of about 1 m. The cooling system has a mini diaphragm pump and a DC electric fan with the maximum power consumptions of 8.4 W and 0.96 W respectively. The coefficient of performance of the system is 21.4. (c) 2005 Elsevier Ltd. All rights reserved.