期刊
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY
卷 170, 期 1-2, 页码 121-126出版社
ELSEVIER SCIENCE SA
DOI: 10.1016/j.jmatprotec.2005.04.111
关键词
high speed end milling; tool steels; flank wear; surface roughness
In this work, high speed end milling of AISI D3 cold-work tool steel hardened to 35 HRC was investigated using coated carbide, coated cermet, alumina (Al2O3) based mixed ceramic and cubic boron nitride (CBN) cutting tools. Performances of the cutting tools were compared with respect to tool life and surface finish of the workpiece. The results were also discussed in terms of tool cost. The best cutting performance was obtained with CBN tool. TiCN mixed Al2O3 ceramic tool also proved to be suitable for high speed end milling of AISI D3 steel with 35 HRC. Coated carbide and coated cermet tools, on the other hand, did not exhibit good performance in high speed cutting operations. They should rather be used at low or moderate cutting speeds. (c) 2005 Elsevier B.V. All rights reserved.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据