Sequential analysis of multiple analytes using a surface plasmon resonance (SPR) biosensor

A sequential analysis method for the analysis of two analytes was developed using a surface plasmon resonance (SPR) biosensor. A sample with both analytes was introduced into the single sensing region and then each analyte was analyzed sequentially. Two detection models were devised for the samples with the following composition: (1) one target analyte resulting in a sensor response without any label and the other analyte with only additional label, (2) both target analytes requiring additional labels for detection. A standard curve for each model was prepared and applied for sequential analysis of anti-bovine serum albumin (anti-BSA) antibodies and horseradish peroxidase (HRP). The errors of the sequential analysis of Models I and 2 were found to be less than 6%, and this method was therefore acceptable for application. No cross-reaction arising from non-specific binding among the participating antigens and antibodies was shown to occur in Models 1 and 2. For optimization of the analyte binding capacity of immutioaffinity (IA), the concentration ratio of the molecular recognition element at the immobilization step was adjusted. Subsequently, from the measurement of the maximum sensor response (R-max), optimization of the analyte binding capacity could be made. Using Model 2, the feasibility of sequential analysis was demonstrated by detecting levels of human chorionic gonadotropin (hCG) and human albumin (hA) in healthy human urine, since both proteins are known to be related to abortion and preterm delivery during early pregnancy. (c) 2006 Elsevier B.V. All rights reserved.