期刊
SURFACE & COATINGS TECHNOLOGY
卷 200, 期 24, 页码 6854-6862出版社
ELSEVIER SCIENCE SA
DOI: 10.1016/j.surfcoat.2005.10.032
关键词
hardfacing alloys; laser cladding; plasma spraying; wear
In this work, the influence of the processing conditions on the microstructure and abrasive wear behaviour of a NiCrBSi hardfacing alloy is analysed. The hardfacing alloy was applied in the form of coatings onto a mild steel substrate (Fe-0.15%C) by different techniques: laser cladding (LC) and flame spraying (FS) combined with surface flame melting (SFM). In both cases, the appropriate selection of the process parameters enabled high-quality, defect-free NiCrBSi coatings to be obtained. The microstructure of the coatings was analysed by scanning electron microscopy (SEM), with attached energy dispersive spectroscopy (EDS) microprobe, and by X-ray diffraction (XRD). Their tribological properties were evaluated by micro-scale ball cratering abrasive wear tests using different abrasives: diamond, SiC and WC. Microstructural characterisation. showed that both coatings exhibit similar phases in their microstructure, but the phases present differ in morphology, size distribution and relative proportions from one coating to another. Wear tests showed that in three-body abrasive conditions, despite these microstructural differences, the wear behaviour is comparable for both coatings. Conversely, in two-body wear conditions with diamond particles as the abrasive, it was observed that the specific wear rate of the material is sensitive to microstructural. changes. This fact is particularly apparent in LC coatings, in which the zones of the layers with higher proportions of very small hard particles present a lower wear resistance. These results indicate that it is important to have good microstructural control of this material, in order to obtain coatings with an optimized and homogeneous tribological behaviour. (c) 2005 Elsevier B.V. All rights reserved.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据