Effect of membrane fouling on transport of organic contaminants in NF/RO membrane applications

Commercial polyamide nanofiltration (NF), reverse osmosis (RO), and ultra-low pressure RO (ULPRO) membranes (NF-90, NF-200, TFC-HR, and XLE) as well as a cellulose triacetate RO membrane (CTA) were employed to investigate the effect of fouling oil transport of organic micropollutants. Due to foulant precipitation and cake-layer formation. membrane Surface characteristics changed considerably in terms of contact angle (an index of hydrophobicity), zeta-potential, functionality, and surface morphology,,which potentially affected transport of contaminants as compared to unfouled (virgin) membranes. The transport of ionic organic micropollutants was hindered as a result of improved Donnan exclusion (electrostatic repulsion) likely due to a more negative surface charge as quantified by zeta-potential measurements. Membrane fouling also resulted in an increased adsorption capacity and reduced mass transport through partitioning and diffusion Of Solutes across the membrane. These effects led to an increase in rejection of hydrophobic non-ionic solutes (e.g., disinfection by products and chlorinated solvents) by fouled membranes. However, the increasing surface charge has the potential to result in a larger molecular weight cut-off of a fouled membrane due to membrane swelling. which can lead to lower rejection for hydrophilic non-ionic solutes, especially where nanofiltration membranes with a larger molecular weight cut-off are employed. Membrane fouling facilitated the transport of hydrophobic and hydrophilic organic contaminants through CTA membranes resulting in elevated concentrations of target solutes in the permeate. Findings of the study indicate that membrane fouling significantly affects the rejection of organic solute by CTA, NF, and ULPRO membranes while it is less important for thin film composite RO membranes. (c) 2005 Elsevier B.V. All rights reserved.