Blown films of nanocomposites prepared from low density polyethylene and a sodium ionomer of poly(ethylene-co-methacrylic acid)

A detailed study of the performance of blown films prepared from nanocomposites based on LDPE and a sodium ionomer of poly(ethylene-co-methacrylic acid) is reported. The organoclay content and film blowing conditions were varied to determine the effect of platelet concentration, exfoliation and orientation on film properties. Mechanical properties including stiffness, puncture resistance, and resistance to tear propagation were evaluated and compared to corresponding properties of unfilled polymer films. Permeability of the films to moisture and common atmospheric gases like oxygen, nitrogen, and carbon dioxide was also measured using standard testing methods. In general, films prepared from nanocomposites based on the ionomer exhibited greater improvements in mechanical and barrier properties over unfilled polymer compared to similar films prepared from nanocomposites based on LDPE. This is due to the greater degree of organoclay exfoliation achieved in the ionomer compared to LDPE. The addition of 3 wt% MMT to the ionomer increased the tensile modulus of blown films by an average of 50% without sacrificing much tear strength, puncture resistance or film extensibility. Gas permeability in these films was lowered by 40% and moisture transmission rate was reduced by 60%. (c) 2006 Elsevier Ltd. All rights reserved.