In situ oil/water separation using hydrophobic-oleophilic fibrous wall: A lab-scale feasibility study for groundwater cleanup

Kapok, a natural plant fiber, possesses excellent hydrophobic-oleophilic characteristics. Its innovative use as hydrophobic-oleophilic wall that allows permeation of oil but not water into an oil recovery well is proposed. Its performance was investigated through laboratory experiments, in which diesel was used as the experimental oil. A two-dimensional hydraulic flume was setup to physically model the oil/water separation by the kapok wall. The influences of packing density, kapok wall thickness and oil thickness on the oil recovery rate were examined. The oil permeability of the packed kapok decreased from 0.0165 cm(2) at 34 g/L packing density to 0.0038 cm(2) at 70 g/L packing density. The kapok wall exhibited complete rejection of water while allowed oil to permeate through. The excellent oil/water separation by the kapok wall was due to surface interaction between the kapok fibers and the oil, which resulted in spontaneous penetration and permeation of the oil through the kapok wall. The oil recovery rate increased with thickness of the oil layer in the feed stream. When the oil thickness exceeded 60 mm, a constant flux of 3.8-5.0, 3.2-3.3 and 2.5-2.7 L/(m(2) min) could be achieved by the kapok wall of 55-, 75- and 95-mm thick, respectively, under the natural pressure gradient. The kapok wall could be reused for several wetting/drying cycles, and only lost 27% of its initial oil permeability. (c) 2006 Elsevier B.V. All rights reserved.