Laser rapid manufacturing of Colmonoy-6 components

This paper introduces a new manufacturing technique for the fabrication of Colmonoy-6 components using laser rapid manufacturing (LRM). LRM is a upcoming rapid manufacturing technology, being developed at various laboratories around the world. It is similar to laser cladding at the process level with different end applications. In general, laser cladding technique is used to deposit material on the substrate either to improve the surface properties or to refurbish the worn out parts, while LRM is capable of near net shaping the components by layer-by-layer deposition of the material directly from CAD model. In the present study, a high power continuous wave (CW) CO2 laser system, integrated with a co-axial powder-feeding system and three-axis workstation was used. The effect of processing parameters during multi-layer deposition of Colmonoy-6 has been studied and optimized to fabricate about a dozen bushes. Thus fabricated bushes were finally machined and ground to achieve the desired dimensions and surface finish. These bushes were tested for non-destructive testing (like-ultra sonic testing, Dye-penetrant testing), metallographic examinations, micro-hardness measurement, X-ray diffraction and thermal ageing. Results compared well with those fabricated by deposition of Colmonoy-6 on austenitic stainless steel rods using gas Tungsten arc welding (GTAW). Thus, the new manufacturing technique not only produced quality product, but also minimized machining of hard-faced material and brought significant saving of time and costly Colmonoy-6 material. (C) 2005 Elsevier Ltd. All rights reserved.