Location and quantification of noise sources on a wind turbine

Acoustic field measurements were carried out on a three-bladed wind turbine with a rotor diameter of 58 in, in order to characterize the noise sources and to verify whether trailing edge noise from the blades was dominant. To assess the effect. of blade roughness, one blade was cleaned, one blade was tripped, and one blade remained untreated. A large horizontal microphone array, positioned about one rotor diameter upwind from the turbine, was used to measure the distribution of the noise sources in the rotor plane and on the individual blades. The operation parameters of the turbine were recorded in parallel to the acoustic tests. In total more than 100 measurements were performed at wind speeds between 6 and 10 m/s. The array results reveal that besides a minor source at the rotor hub, practically all noise (emitted to the ground) is produced during the downward movement of the blades. This strongly asymmetric source pattern can be explained by convective amplification and trailing edge noise directivity. The blade noise is produced at the outer part of the blades (but not at the very tip), and the level scales with the fifth power of the local flow speed. Comparison of the noise from the individual blades shows that the tripped blade is significantly noisier than the other two. Narrowband analysis of the de-dopplerized blade noise spectra indicates that trailing edge bluntness noise is not important. All in all, the test results convincingly show that broadband trailing edge noise is the dominant noise source for this wind turbine. (c) 2006 Elsevier Ltd. All rights reserved.