Effect of the drawing process on the wet spinning of polyacrylonitrile fibers in a system of dimethyl sulfoxide and water

The effect of the drawing process on the structural characteristics and mechanical properties of polyacrylonitrile (PAN) fibers was comparatively studied. The protofibers extruded from the spinneret were the initial phase of stretching, which involved the deformation of the primitive fiber with the concurrent orientation of the fibrils. Wet-spun PAN fibers observed by scanning electron microscopy exhibited different cross-sectional shapes as the draw ratio was varied. X-ray diffraction results revealed that the crystalline orientation of PAN fibers increased with increasing draw ratio; these differences in the orientation behaviors were attributed to the various drawing mechanisms involved. The crystalline and amorphous orientations of the PAN fibers showed different features; at the same time, the tensile properties were strongly dependent on the draw ratio. However, the stream stretch ratio had most influence on the tensile strength and the orientation of PAN fibers for the selected process parameters. Electron spin resonance proved that the local morphology and segmental dynamics of the protofibers were due to a more heterogeneous environment caused by the sequence structure. Differential scanning calorimetry indicated that the size and shape of the exotherm and exoenergic reaction were strongly dependent on the morphology and physical changes occurring during fiber formation. (c) 2007 Wiley Periodicals, Inc.