Recent progress in second-generation HTS conductor scale-up at SuperPower

YBa2Cu3Ox (YBCO) second-generation (2G) HTS conductors have been produced in lengths over 300 m in pilot scale facilities established at SuperPower. High throughput pilot-scale manufacturing has been demonstrated with tape speeds at or above 30 m/h of 12 mm wide tape (corresponding to 90 m/h of 4 mm wide conductor) in all steps. A 322 m long conductor with a minimum critical current value of 219 A/cm has been produced, which corresponds to a critical current x length value of 70,520 A-m. A 270 m long, 4 mm wide conductor with an end-to-end critical value of 100 A has also been demonstrated. In a campaign to manufacture 2G conductor for the Albany cable project, SuperPower has produced 12,470 m of conductor that meets or exceeds the specification for piece length (42.4 m) and critical current (100 A/cm). In fact, more than 55% of the conductor produced is at least 100 to in piece length and more than 27% greater than 200 m in piece length. In addition to scaling up 2G conductors to high-throughput pilot-scale manufacturing, we have demonstrated high critical currents in short samples produced by Metal Organic Chemical Vapor Deposition (MOCVD). Critical current values of 557 A/cm have been achieved in 2.1 micrometer thick films in 12 turn wide, 10 cm long tapes. These samples exhibit a critical current value of 116 A/cm at 1 T and 76 K, in the orientation of field parallel to the c-axis. We have also constructed a 4-pancake coil that generated a magnetic field of 1.1 T at 77 K and 2.4 T at 64 K. A Fault Current Limiter (FCL) assembly has been successfully constructed and tested at high power levels. A prospective current of 90 kA was successfully limited to 32 kA within 1 ms without any HTS element failure.