Effect of surfactant in a modified sol on the physicochemical properties and photocatalytic activity of crystalline TiO2 nanoparticles

This study describes the effect of amphiphilic organic molecules (surfactants) in a sol on the physicochemical properties and photocatalytic activity of crystalline TiO2 nanoparticles prepared via a simple sol-gel route at high temperatures from 400 to 800 degrees C. Addition of polyoxyethylenesorbitan surfactant and polyethylene oxide and polypropylene oxide triblock copolymer as particle size inhibitors and pore directing agents into a stable titania sol affected the physicochemical properties of TiO2 nanoparticles such as their crystallographic structure, morphology, and defect structure. With the addition of the surfactants, the ratio of anatase and rutile crystal phases of TiO2 was controlled and an active anatase crystal phase was maintained during heat treatment up to 800 degrees C. Decrease in the sintering rate and inhibition in crystal growth were also observed, which resulted in higher surface area and inhibition of crystallite aggregation. Bulk defects in TiO2 were reduced while surface defects were increased as a result of the addition of surfactants. These physicochemical properties of TiO2 nanoparticles were correlated with photocatalytic degradation of 4-chlorophenol in water. The results revealed that high crystallinity, anatase crystal phase, high specific surface area, surface defects, and segregated morphology of TiO2 nanoparticles, which were induced by the addition of surfactants, were more advantageous for enhancing photocatalytic destruction of the model organic compound tested in the study.