Integral-based constitutive equation for rubber at high strain rates

High-speed experiments were conducted to characterize the deformation and failure of Styrene Butadiene Rubber at impact rates. Dynamic tensile stress-strain curves of uniaxial strip specimens and force-extension curves of thin sheets were obtained from a Charpy tensile impact apparatus. Results from the uniaxial tension tests indicated that although the rubber became stiffer with increasing strain rates, the stress-strain curves remained virtually the same above 280 s(-1). Above this critical strain rate, strength, fracture strain and toughness decreased with increasing strain rates. When 1 strain rates were below 180 s(-1) the initial modulus, tensile strength and breaking extension increased as the strain rate I increased. Between strain rates of 180 and 280 s(-1) the initial modulus and tensile strength increased with increasing strain rates but the extension at break decreased with increasing strain rates. A hyper-viscoelastic constitutive relation of integral form was used to describe the rate-dependent material behavior of the rubber. Two characteristic relaxation times, 5 ins and 0.25 ms, were needed to fit the proposed constitutive equation to the data. The proposed constitutive equation was implemented in ABAQUS Explicit via a user-defined subroutine and used to predict the dynamic response of the rubber sheets in the experiments. Numerical predictions for the transient deformation and failure of the rubber sheet were within 10% of experimental results. (C) 2007 Elsevier Ltd. All rights reserved.