4.7 Article

Electrospinning of polyacrylonitrile solutions at elevated temperatures

期刊

MACROMOLECULES
卷 40, 期 22, 页码 7973-7983

出版社

AMER CHEMICAL SOC
DOI: 10.1021/ma070508n

关键词

-

向作者/读者索取更多资源

Using a jacket-type heat exchanger to control the solution temperature, the electrospinning of pot yacryl onitrile/dimethylformamide (PAN/DMF) solutions with various concentrations was carried out at temperatures ranging from ambient to 88.7 degrees C. The purpose of this is to investigate the temperature effect on the cone/jet/fiber morphologies that developed. By varying the solution temperature, the chain entanglement status existing in the solution (which is the prerequisite condition for preparing uniform fibers) remained intact. However, the solution properties were significantly altered, thereby giving rise to a feasible route to manipulate the as-spun fiber diameter. By increasing the solution temperature, it was found that the viscosity (eta(o)) and surface tension (gamma) of the PAN/DMF solutions were decreased, but the solution conductivity (K) was increased; all these trends favored the development of thinner electrospun PAN fibers at high electrospinning temperatures. For instance, with the 6 wt % solutions, PAN fibers with a diameter of 65-85 nm were readily prepared by electrospinning at 88.7 degrees C, whereas larger fibers with a diameter of 190-240 nm were frequently obtained at room temperature. The temperature dependence of eta(o), gamma, and K followed the Arrhenius equation, and the corresponding activation energies were composition dependent and found to be ca. 157-28, similar to 10 and similar to 3.7 W/mol, respectively. High-temperature electrospinning eventually produced PAN fibers with less crystallinity but higher chain orientation as revealed by the wide-angle X-ray diffraction and birefringence measurements. Moreover, the scaling law for the viscosity dependence of fiber diameter, d(f), was also altered from df = 14.8 eta(0.52)(o) (unit: df in nm and eta(o) in cP) at room temperature to df = 3.0 eta(0.74)(o), at 88.7 degrees C, suggesting that high-temperature electrospinning was an effective method to produce ultrathin fibers.

作者

我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。

评论

主要评分

4.7
评分不足

次要评分

新颖性
-
重要性
-
科学严谨性
-
评价这篇论文

推荐

暂无数据
暂无数据