相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。An examination of the fundamental mechanics of cutting force coefficients
Minghai Wang et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2014)
Hybrid modelling of sliding-sticking zones at the tool-chip interface under dry machining and tool wear analysis
S. Bahi et al.
WEAR (2012)
A new friction law for sticking and sliding contacts in machining
S. Bahi et al.
TRIBOLOGY INTERNATIONAL (2011)
Cutting force modeling for flat end milling including bottom edge cutting effect
Jian-Wei Dang et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2010)
A critical analysis on the friction modelling in orthogonal machining
L. Filice et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2007)
Thermomechanical modelling of oblique cutting and experimental validation
A Moufki et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2004)
A model for the contact conditions at the chip-tool interface in machining
B Ackroyd et al.
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2003)
Milling force prediction using a dynamic shear length model
HZ Li et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2002)
Adiabatic shear banding in high speed machining of Ti-6Al-4V: experiments and modeling
A Molinari et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2002)
Modeling the high strain rate behavior of titanium undergoing ballistic impact and penetration
HW Meyer et al.
INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2001)
Modelling of cutting forces in helical end milling using a predictive machining theory
HZ Li et al.
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2001)
Thermoviscoplastic modelling of oblique cutting: forces and chip flow predictions
A Moufki et al.
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2000)