Improving the Electrical Contact Performance for Amorphous Wire Magnetic Sensor by Employing MEMS Process

This paper presents a novel fabrication method for amorphous alloy wire giant magneto-impedance (GMI) magnetic sensor based on micro electro mechanical systems (MEMS) technology. In this process, negative SU-8 thick photoresist was proposed as the solder mask due to its excellent properties, such as good stability, mechanical properties, etc. The low melting temperature solder paste was used for the electrical connections with the amorphous alloy wire and the electrode pads. Compared with the conventional welding fabrication methods, the proposed micro electro mechanical systems (MEMS) process in this paper showed the advantages of good impedance consistency, and can be fabricated at a low temperature of 150 degrees C. The amorphous alloy wire magnetic sensor made by the conventional method and by the micro electro mechanical systems (MEMS) process were tested and compared, respectively. The minimum resistance value of the magnetic sensor made by the conventional welding method is 19.8 and the maximum is 28.1 . The variance of the resistance is 7.559 (2). The minimum resistance value of the magnetic sensor made by micro electro mechanical systems (MEMS) process is 20.1 and the maximum is 20.5 . The variance of the resistance is 0.029 (2). The test results show that the impedance consistency by micro electro mechanical systems (MEMS) process is better than that of the conventional method. The sensor sensitivity is around 150 mV/Oe and the nonlinearity is less than 0.92% F.S.