Removal of safranin dye from water using polypyrrole nanofiber/Zn-Fe layered double hydroxide nanocomposite (Ppy NF/Zn-Fe LDH) of enhanced adsorption and photocatalytic properties

Polypyrrole nanofiber/Zn-Fe layered double hydroxide (Ppy NF/Zn-Fe LDH) was synthesized as nanocomposite of enhanced adsorption and photocatalytic properties. The formation of the composite was confirmed by XRD, FT-IR, HSEM, HRTEM, BET surface area and UV-vis spectrophotometer. Ppy NF/Zn-Fe LDH composite exhibits clear enhancing in the specific surface area and obvious reducing in the band gap energy (from 2.8 eV for ZnFe LDH to 2.31 eV for the composite). This was reflected in a considerable improvement in the adsorption capacity and photocatalytic removal of safranin dye. The adsorption capacity was enhanced by about 22% higher than Ppy NF and by 31% higher than Zn-Fe LDH. The photocatalytic removal was improved by 41.6% higher than Ppy NF and by about 54% higher than Zn-Fe LDH. The adsorption of safranin dye by the composite is chemisorption adsorption and occurs in a multilayer form. The complete photocatalytic removal of 5 mg/L of safranin dye can be achieved after 120 min illumination time using 0.05 g of the composite as photocatalyst and the best results can be obtained at neutral to alkaline conditions. Realistic application of the composite for the removal of dye from raw water samples revealed the applicability of the product for the purification of tap water, groundwater, and sewage water. Moreover, it can be used for six cycles of safranin dye removal from water. The photocatalytic degradation process appears to be controlled by the created hydroxyl radicals and formed photogenerated holes as the dominant active oxidizing radicals. (C) 2018 Elsevier B.V. All rights reserved.