Research into the mechanical properties, sintering mechanism and microstructure evolution of Al2O3-ZO(2) composites fabricated by a stereolithography-based 3D printing method

In this paper, a ceramic suspension with appropriate viscosity was prepared by optimizing the powder solid content and the dispersant content. An Al2O3-ZrO2 ceramic green body was fabricated using the SLA technique, followed by the application of a liquid drying and two-step debinding process to prepare the defect-free Al2O3-ZrO2 ceramic green body. The relative density, phase composition, microstructure, grain size, and mechanical properties of Al2O3-ZrO2 samples sintered at different temperatures were compared. The main results indicated that the sample density increased with the sintering temperature until reaching a maximum density of 4.28 g/cm(3) at 1600 degrees C. When the temperature further increased to 1650 degrees C, the density dropped instead. With increasing sintering temperature, both the number of grain boundaries and the number of pores located at the grain boundaries reduced greatly. The Vickers hardness of the samples first increased and reached its maximum at 1550 degrees C with a value of 17.6 GPa, and then decreased with further increases in sintering temperature. The fracture toughness increased with the sintering temperature and reached a maximum value of 5.2 MPa.m(1/2) at 1650 degrees C. A sintering kinetics window which could offer the relationship between the sintering temperature and the relative density & grain size was set and also the microstructure evolution of the sintered body was conducted to get a deeper understanding of the 3D printing Al2O3-ZrO2 composites. (C) 2017 Elsevier B.V. All rights reserved.