Effect of filler wire on laser welded blanks of Al-Si-coated 22MnB5 steel

Carbon-steel filler wire was used to solve the coating problem in laser welded blanks of Al-Si-coated 22MnB5 without a decoating procedure. The effect of the filler wire on the fusion-zone microstructure and mechanical properties was investigated. The Al content was diluted by the filler wire. The delta-ferrite phase was also reduced after the reduction in Al and homogenization. The joint strength was similar to 1210 MPa, and the elongation was 1.1% without filler wire. When filler wire was used, the joint strength increased to 1550 MPa, and the elongation was greater than 3%. The fracture surface of the joint with the filler wire was ductile. The effects of welding speed and feeding speed were also studied. A reduction in the Al content at the higher feeding speed or the use of a slower welding speed was found to be most effective because either approach enabled more filler material to be added to lower the ratio of the Al-Si coating in the fusion zone. In the absence of the filler wire, the delta-ferrite phases were large and long, connecting to a bulk zone. When the filler wire was used, the delta-ferrite phases were broken up and became narrow and small with a uniform distribution in the martensite matrix.