High manganese TWIP steel - technological plasticity and selected properties

Over the last few years national as well as international research centres conducting research on the development of high-manganese steels. Some of these materials belong to the group of AHS steels, are characterized by the twinning induced plasticity (TWIP) effect which is a new type of steel possessing together with high strength a great plastic elongation, and an ideal uniform work hardening behavior. It is therefore a good candidate for deep drawing applications in the automobile and railway industry. The article presents the results of researches of TWIP-type austenitic steel in case of determination some of the more important parameters for continuous casting simulation process and the results of tests regarding the influence of strain parameters on sensitivity to plastic forming and deformation strengthening. It has been shown that the researched steel reaches a zero plasticity temperature at 1250 degrees C. The deformation tests indicate its good workability of hot processing within the temperature range of 1100 divided by 800 degrees C. The relation between flow stress and strain during the hot deformation is typical for the presence of dynamic recrystallization processes. The tested steel has good formability and high mechanical properties, especially when being deformed at a high strain rate. Analysis of the substructure of researched steel was indicate presence of mechanical twinning.