相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Study of the control strategies on soot reduction under early-injection conditions on a diesel engine
Haifeng Liu et al.
FUEL (2015)
Effect of flat-wall impingement on diesel spray combustion
Kuichun Li et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING (2015)
CHARACTERISTICS OF ADHESION DIESEL FUEL ON AN IMPINGEMENT DISK WALL. PART 3: AMBIENT PRESSURE EFFECT
Mohd Zaid Akop et al.
ATOMIZATION AND SPRAYS (2014)
CHARACTERISTICS OF ADHESION DIESEL FUEL ON AN IMPINGEMENT DISK WALL PART 2: DROPLET WEBER NUMBER AND ADHERED FUEL MASS
Mohd Zaid Akop et al.
ATOMIZATION AND SPRAYS (2014)
Numerical study of effects of reformed exhaust gas recirculation (REGR) on dimethyl ether HCCI combustion
Zhaolei Zheng et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2014)
CHARACTERISTICS OF ADHESION OF DIESEL FUEL ON IMPINGEMENT DISK WALL. PART 1: EFFECT OF IMPINGEMENT AREA AND INCLINATION ANGLE OF DISK
Mohd Zaid Akop et al.
ATOMIZATION AND SPRAYS (2013)
EXPERIMENTAL INVESTIGATIONS ON ADHERED FUEL AND IMPINGING DIESEL SPRAY NORMAL TO A WALL
Mohd Zaid Akop et al.
ATOMIZATION AND SPRAYS (2013)
Effect of a cross-flow on spray impingement with port fuel injection systems for HCCI engines
Miguel R. Oliveira Panao et al.
FUEL (2013)
Numerical investigation of the combustion characteristics and wall impingement with dependence on split-injection strategies from a gasoline direct-injection spark ignition engine
Juhyeong Seo et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING (2013)
Conceptual models for partially premixed low-temperature diesel combustion
Mark P. B. Musculus et al.
PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2013)
An experimental study on spray characteristics after impingement on a piston surface through an asymmetrical multi-hole injector of a direct-injection spark ignition gasoline engine
Q. Fan et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING (2012)
NEAR-WALL CHARACTERISTICS OF AN IMPINGING GASOLINE SPRAY AT INCREASED AMBIENT PRESSURE AND WALL TEMPERATURE
Jochen Stratmann et al.
ATOMIZATION AND SPRAYS (2011)
Fuel design and management for the control of advanced compression-ignition combustion modes
Xingcai Lu et al.
PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2011)
Optical investigations of fuel deposition burning in ported fuel injection (PFI) spark-ignition (SI) engine
Simona S. Merola et al.
ENERGY (2009)
Progress and recent trends in homogeneous charge compression ignition (HCCI) engines
Mingfa Yao et al.
PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2009)
An experimental study on flat-wall-impinging spray of microhole nozzles under ultra-high injection pressures
W. Zhang et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING (2008)
The influence of fuel injection and heat release on bulk flow structures in a direct-injection, swirl-supported diesel engine
Paul C. Miles et al.
EXPERIMENTS IN FLUIDS (2007)
Combined measurements of flow structure, partially oxidized fuel, and soot in a high-speed, direct-injection diesel engine
Paul C. Miles et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2007)
Macroscopic and microscopic characteristics of a fuel spray impinged on the wall
SW Park et al.
EXPERIMENTS IN FLUIDS (2004)
分享论文
