Manganese oxide-based catalysts for toluene oxidation

Four different catalysts based on manganese oxide were prepared: a perovskite (LaMnO3), via sol-gel method; Mn203, rapid method and an Octahedral Molecular Sieve (OMS-2) by two different preparation methods, via solid state (OMSs) and hydrothermal method (OMSh). The physicochemical properties of these catalysts were characterized by X-ray diffraction (XRD), N2 adsorption-desorption at -196 degrees C, thermogravimetric and differential thermal analysis (TGA/DTA), inductively coupled plasma optical emission spectroscopy (ICP-OES) and temperature-programmed reduction with hydrogen (H-2-TPR). Their catalytic performances were evaluated in the catalytic oxidation of toluene. Three consecutive catalytic cycles were performed for each catalyst in order to reach steady state performances. In order to assess the stability of the catalysts under reaction conditions, the catalytic performances were studied upon long term experiments running for 24 hat 25% of toluene conversion. For comparison purposes, the catalytic activity of the present manganese oxide catalysts was compared with that of typical industrial catalysts such as a commercial Pd/Al2O3 catalyst containing 0.78% Pd. The crystalline features detected in the XRD patterns, are well-consistent with the formation of the desired structures. Based on their specific surface area and their low-temperature reducibility, the catalysts were ranked as follows: OMSS > Mn2O3 > OMSh > LaMn03. This trend was in good agreement with the performances observed in the catalytic removal of toluene. A kinetic model was proposed and a good agreement was obtained upon fitting with the experimental data. (C) 2017 Elsevier B.V. All rights reserved.