相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。A Semi-deterministic Wear Model Considering the Effect of Zinc Dialkyl Dithiophosphate Tribofilm
Ali Ghanbarzadeh et al.
TRIBOLOGY LETTERS (2016)
Development of a new mechano-chemical model in boundary lubrication
Ali Ghanbarzadeh et al.
TRIBOLOGY INTERNATIONAL (2016)
The Influence of Slide-Roll Ratio on ZDDP Tribofilm Formation
Yasunori Shimizu et al.
TRIBOLOGY LETTERS (2016)
On the Mechanism of ZDDP Antiwear Film Formation
Jie Zhang et al.
TRIBOLOGY LETTERS (2016)
Roughness evolution in mixed lubrication condition due to mild wear
G. E. Morales-Espejel et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2015)
Mechanisms of antiwear tribofilm growth revealed in situ by single-asperity sliding contacts
N. N. Gosvami et al.
SCIENCE (2015)
Micropitting Performance of Oil Additives in Lubricated Rolling Contacts
V. Brizmer et al.
TRIBOLOGY TRANSACTIONS (2013)
Semi-deterministic chemo-mechanical model of boundary lubrication
Joel Andersson et al.
FARADAY DISCUSSIONS (2012)
The Composition of Reaction Layers on Rolling Bearings Lubricated with Gear Oils and Its Correlation with Rolling Bearing Performance
H. R. Pasaribu et al.
TRIBOLOGY TRANSACTIONS (2012)
The influence of base oil polarity and slide-roll ratio on additive-derived reaction layer formation
A. Naveira-Suarez et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2011)
Micropitting Modelling in Rolling-Sliding Contacts: Application to Rolling Bearings
G. E. Morales-Espejel et al.
TRIBOLOGY TRANSACTIONS (2011)
Micro-geometry effects on the sliding friction transition in elastohydrodynamic lubrication
G. E. Morales-Espejel et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2010)
The Effect of a Friction Modifier Additive on Micropitting
E. Laine et al.
TRIBOLOGY TRANSACTIONS (2009)
Effect of lubricants on micropitting and wear
E. Laine et al.
TRIBOLOGY INTERNATIONAL (2008)
Rapid calculation of the pressures and clearances in rough, rolling-sliding elastohydrodynamically lubricated contacts. Part 2: general, non-sinusoidal roughness
C. J. Hooke et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2007)
Study of zinc dialkydithiophosphate antiwear film formation and removal processes, part I: Experimental
H Fujita et al.
TRIBOLOGY TRANSACTIONS (2005)
Study of zinc dialkyldithiophosphate antiwear film formation and removal processes, part II: Kinetic model
H Fujita et al.
TRIBOLOGY TRANSACTIONS (2005)
The formation of zinc dithiophosphate antiwear films
H Fujita et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2004)
An engineering approach on sliding friction in full-film, heavily loaded lubricated contacts
GE Morales-Espejel et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2004)
Frequency response functions and rough surface stress analysis
JH Tripp et al.
TRIBOLOGY TRANSACTIONS (2003)
Friction-enhancing properties of ZDDP antiwear additive: Part I - Friction and morphology of ZDDP reaction films
LJ Taylor et al.
TRIBOLOGY TRANSACTIONS (2003)
分享论文
