4.6 Article

Electrochemical and photocurrent characterization of polymer solar cells with improved performance after GO addition to the PEDOT:PSS hole transporting layer

期刊

SOLAR ENERGY
卷 146, 期 -, 页码 230-242

出版社

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.solener.2017.02.032

关键词

Graphene oxide; Polymer solar cells; Electrochemical properties

资金

  1. IPN
  2. [SIP-IPN 20161804/0291]

向作者/读者索取更多资源

In this paper, chemically synthesized graphene oxide (GO) was added to modify the performance and electrochemical properties of bulk heterojunction polymer solar cells (PSCs) with different architectures. GO was obtained by modified Hummers method and fully characterized by Raman spectroscopy, Fourier Transform Infrared Spectroscopy, X-ray diffraction as well as with cyclic voltammetry (CV). Bulk heterojunction PSCs with P3HT:PC61BM or PTB7:PC71BM active layers and PEDOT:PSS as hole transport layers (HTL) were constructed and investigated relative to: (i) concentration of GO in HTL, (ii) acidity of GO, (iii) type of polymer used in active layer, (iv) annealing temperature of the active layer and (v) place where GO is incorporated in the devices. For PSCs, the best performance was obtained for device with the ITO/PEDOT:PSS:GO/PTB7:PC71BM/A1 architecture when the volume ratio of PEDOT:PSS to GO was 1:1. Under these conditions, a power conversion efficiency (PCE) of 5.22% with open circuit voltage V-oc = 0.654 V, short circuit current density J(sc) = 15.17 mA/cm(2), and fill factor FF = 0.53 were achieved. It is shown that for devices with P3HT:PC61BM active layer, a better performance of device was achieved for the active layer annealed at 130 degrees C instead of 75 degrees C. For the ITO/(PEDOT:PSS):GO (1:1)/P3HT: PC61BM (75 degrees C)/Al device about 75% higher PCE was found compared with reference device (PCE for device without GO = 0.64%, while PCE for device with GO = 1.07%). The influence of GO on energy gap and HOMO-LUMO levels in PEDOT:PSS was investigated by CV method. The observed effect of GO in the HTL is to reduce the HOMO-LUMO gap and to shift the LUMO position downwards in energy, with the GO contents. The devices were additionally tested by electrochemical impedance spectroscopy (EIS) and well-fitted equivalent circuits were proposed. (C) 2017 Elsevier Ltd. All rights reserved.

作者

我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。

评论

主要评分

4.6
评分不足

次要评分

新颖性
-
重要性
-
科学严谨性
-
评价这篇论文

推荐

暂无数据
暂无数据