Selective CO2 Capture by Activated Carbons: Evaluation of the Effects of Precursors and Pyrolysis Process

Activated carbons are produced from different Canadian waste biomasses including agricultural waste (wheat straw and flax straw), forest residue (sawdust and willow ring), and animal manure (poultry litter). The precursors are carbonized through the fast and slow pyrolysis processes and then activated with potassium hydroxide. A fixed-bed reactor is used for temperature swing adsorption of CO2 in a gas mixture of N-2, O-2, and CO2 to study the cyclic CO2 adsorption capacity and selectivity of the produced activated carbons. The breakthrough adsorption capacity of the produced activated carbon is measured under a flue gas condition of 15 mol % of CO2, 5 mol % of O-2, and 80% of N-2 at 25 degrees C and atmospheric pressure. Slow pyrolysis based activated carbon has a lower surface area and total pore volume but higher adsorption capacity in the presence of N-2. Sawdust based activated carbon synthesized using the slow pyrolysis process creates the highest ultra-micropore volume of 0.36 cm(3)/g, and the highest adsorption capacity in N-2 (78.1 mg/g) but low selectivity (2.8) over O-2 because of the oxygen functional groups on the surface. Ultra-micropores and surface chemistry of adsorbents are far more important than particle size, total pore volume, and internal surface area of the adsorbents. All the samples fully recovered their initial adsorption capacity in each cycle (for up to 10 cycles). This work also demonstrates that adsorption capacity and selectivity of activated carbon can be controlled and optimized through the choice of starting material and carbonization conditions.